open All Channels
seplocked Ships and Modules
blankseplocked [REV] Dominix - LvL 4 Missions w/ Rigs
 
This thread is older than 90 days and has been locked due to inactivity.


 
Author Topic

Sir Erighan
THE MuPPeT FaCTOrY
Minor Threat.
Posted - 2007.01.22 14:39:00 - [1]
 

I’ve looked around, but haven’t seen any thread on it…

I’m looking for lvl 4 mission Dominix builds that “include” the use of 3 CCC rigs. How do these rigs affect other things on your ship? Typically, to run 2 LAR IIs you need 5 CR II in the mids and some nos in the highs. Can the nos be removed and replaced with guns for more dmg? Can any of the CR IIs be removed and replaced with Omni links, tracking CPUs, AB, etc?

Here is a possible template:

Hi
5x 250mm Rails
1x Drone Link

Mid
5x Cap Recharger IIs

Low
2x LAR II / CPR / 4x Hardeners

Rigs
3x Cap Circuits

Thanks

Taipan Gedscho
Muzzletov Gewaltski Inc.
Posted - 2007.01.22 14:46:00 - [2]
 

Edited by: Taipan Gedscho on 22/01/2007 14:43:11
you could actually run the numbers yourself...
your capacitor gives you a "peak recharge", when its at about 33%. (same goes for shields)

the formula is (Capacity/recharge time)*2.4 = peak recharge

then you just look what your modules use, add a litte for safety and now you know, if you can permarun stuff.

numbers may vary a LITTLE (i.e. 30% gives peak or multiplier is 2.5) but still are exact enough to base your calculations on.

mrhateboy
Vale Heavy Industries
Posted - 2007.01.22 14:51:00 - [3]
 

I'm thinking you could probably ditch the CPR or one of the cap rechargers with the CCCs fitted, maybe more than that. I think you can sustain 2 LARs and 4 hardeners with just the modules you have there, rigs excluded.

--H8

Taipan Gedscho
Muzzletov Gewaltski Inc.
Posted - 2007.01.22 14:59:00 - [4]
 

Edited by: Taipan Gedscho on 22/01/2007 14:55:54
just took a look at my domi.

with my skills and with 3xCCC rigs:
3cap recharger IIs and a 24%cap relay run both reppers and 4 hardeners nearly forever (may have to turn one off every few minutes for 2 seconds Very Happy ) -> leaves two medslots

4 cap recharger IIs and a 24% cap relay run both reppers and 4 hardeners forever and youll have spare cap for guns. -> one medslot left

Abyssal Angel
Caldari
The Collective
B O R G
Posted - 2007.01.22 15:21:00 - [5]
 

The setup Im usign and the setup I plan to use with rigs:


Highs:3 X anything, 2 salvagers 1 tractor beam

Meds: 5 Cap recharger II

Lows: 2 T2 LAR, 4 Active hardeners, 1 24 % cap

This setup will run hardeners and the 2 LAR's for almost 10(or so) minutes before 1 of the LAR's needs to be turned off to regain a little cap and then back on.

With Rigs:

Highs:3 X anything, 2 salvagers 1 tractor beam

Meds: 5 Cap recharger II

Lows: 2 T2 LAR, 4 Active hardeners, 1 24 % cap

+ 2 CCC, 1 Nano pump for 15% increased repair amount.

This setup will run all of the above permanently and will leave room to switch one of the T2 Cap rechargers off for an AB, or alternatively fit 3 evil railguns in highslots for increased DPS.
Or if you face a very hard on DPs mission, switch the low slot cap recharger for an EANM or a DCU.

These two setups have an awesome tank and will, if not blow through missions, then at least sit through them :)

Remedios Sonrisa
EVE University
Ivy League
Posted - 2007.01.22 16:32:00 - [6]
 

Oh why did I have to read this damn thread. Now I have to go buy those expensive rigs and break my piggy bank!

Good posts, I have been debating as to what to fit on my Domi/70s-wood-panelled-spacevan myself. I bet things may change a bit however if the drones rigs start to work properly?

Tribunal
FIRMA
Posted - 2007.01.22 18:17:00 - [7]
 

Edited by: Tribunal on 22/01/2007 18:14:45
Originally by: Sir Erighan

Here is a possible template:

Hi
5x 250mm Rails
1x Drone Link

Mid
5x Cap Recharger IIs

Low
2x LAR II / CPR / 4x Hardeners

Rigs
3x Cap Circuits

Thanks



Take advantage of the 25% damage bonus to large hybrids and fit dual 250s, a full rack of them. If you are a serious drone user your max drone base range sould be at least 57km, so ditch the drone link.

Put two tracking computers in your mids to allow yourself the option to insta pop incoming frigs with your 250 duals, and also be able to hit orbiting cruisers.

Drop both tech 2 large reps and purchase 1 X-type large rep. Not only will it allow you to tank any mission in the game, but it will free up one low slot and give you more ease at fitting the 250 duals.

Drop the CPR and put a 1600 tung in its place and a mag stab.

Enjoy your new mission eating Dominix.

Sir Erighan
THE MuPPeT FaCTOrY
Minor Threat.
Posted - 2007.01.23 12:49:00 - [8]
 

Thanks for the input. I tested everything last night in QuickFit.

Hi
5x Dual 250mm Prototype Rails
1x Tractor Beam

Mid
2x Tracking Comps / 3x Cap Recharger IIs

Low
2x LAR II / Beta (24%) CPR / 4x T2 Hardeners

Rigs
3x Cap Circuits

With the above setup, I can run everything for about 4-5 minutes before I need shut one of the LARs off. For the harder missions I will probably drop one tracking comp and replace it with another CR II. This will give me enough cap to run everything indefinitely.

It may not be as good as using a large x-type rep, but despite the CCC rigs, this is a really cheap lvl 4 setup.

Vari
Carbide Industries
Posted - 2007.01.23 18:00:00 - [9]
 

Does anyone know for a fact whether the Auxiliary Nano Pump (armor rep amount) rig had stacking penalities?


 

This thread is older than 90 days and has been locked due to inactivity.


 


The new forums are live

Please adjust your bookmarks to https://forums.eveonline.com

These forums are archived and read-only